Saturday, January 9, 2010

Oy, The Floor

Step 1
remove/clean old flooring

Step 2
We used Novalis Vinyl 4” x 36” planks in Timber Natural Oak from Lowe’s found here.  We cut them exactly in half.  Measure, then score on top with straight edge and utility knife.  Just snap, and stack. We did one, and then used that as the measuring and straight edge for the rest.191 194

Step 3
Decide what you want to line up with.  We decided that we wanted the points to meet in a line centered on the toilet.  Obviously, this will depend on the room you are doing.  Also, when we laid the planks in the toilet area, it was removed for repair.  Much nicer outcome than trying to cut around the toilet, and not really a difficult thing to do.
182

Step 4
At this point, it’s mostly just peel and stick.  So easy, and SOOOO satisfying, because you see the transformation so quickly and easily.  Don’t worry if there are tiny gaps.  It lends authenticity, ala Exquisite Surfaces. 

Step 5
After you get your first 2 rows done and start on the 3rd, you will have some that don’t quite fit.  It’s sooo easy to fix.  Just use your straight edge and super sharp blade and trim where necessary.  Use your next piece to measure and mark, then cut right through.187

Step 6
When you have laid the body of the floor, take your scraps and go around the edges and fill in the smaller bits.  It’s so easy to cut, if you have curves, just use heavy duty scissors.  I think I spent about $60 on this project. 

Scavenger Shop Shots 12-3-09 007

3 comments:

  1. I love this! Did you pull up some ceramic tile in there, were the ceramic tiles applied over the existing tile floor?

    I have some ugly tile that I would love to use this idea to cover, but it's a big room and would be a huge job to pull up the tile...

    ReplyDelete
  2. Amy~ we pulled up old linoleum tiles and had a smooth concrete floor to work with. I would imagine that your grout lines would be the biggest challenge in going over tile. You can buy these vinyl planks individually, so I would just get a couple of them and experiment. Maybe fill the grout lines with some kind of caulk and smooth it out first? Good luck, and I'd love to see pictures if you go for it. ~Dana

    ReplyDelete
  3. Was going to ask the same question Amy asked:) Not sure who's idea it was but my very small bathroom in Philly has the tiles embedded into the concrete so was hoping to be able to cover the floor. Going to utilize your suggestion and buy a few and see how it goes.

    Love your makeover btw!!

    ReplyDelete